Skip to main content
[01.28.2013]

USPS has raised its rates again on Domestic and International Priority Mail shipping.  This seems to have become a yearly thing.  The only upside is that it is still less expensive than UPS and FedEx for both domestic and international shipments.

For the 2012 Christmas Holiday Season, we saw a surge in QS1R orders.  By mid January 2013, we sold out of our current stock of QS1R receivers and have ordered another assembly quantity from our contract assembler.  Luckily, there were no delays caused by parts shortages or back orders.  We will begin shipping new QS1R RevD units from this new lot at the end of January 2013.

Comments

Post a Comment

Popular posts from this blog

History of HPSDR Mercury and Quick Silver

History of HPSDR Mercury and Quick Silver Philip Covington, N8VB Early HPSDR and XYLO In 2005 I started a High Performance SDR (HPSDR) project which was to consist of a motherboard carrying a FPGA/USB 2.0 interface and power supply with the provision for plug in modules through 40 pin headers. I had planned a narrow band high dynamic range module based on a QSD/DDS/PCM4202 audio ADC and a wide bandwidth module based on a high speed 16 bit ADC: http://www.philcovington.com/SDR/PICS/HPSDR_FPGA_USB_Board_top1_800600.jpg http://www.philcovington.com/SDR/PICS/HPSDR_FPGA_USB_Board_top4.jpg I soon selected the LTC2208 ADC from Linear Technology. A representative from Linear Technology came across my blog ( http://pcovington.blogspot.com/ ) and offered evaluation boards and samples to support the project. At about the same time my HPSDR project came about, Phil Harman, VK6APH and Bill Tracey, KD5TFD were interested developing a sound card replacement to be used with the SD...
1 comment
Read more

2323 Wilt

Post a Comment
Read more

RFFE1 Why you may (or may not) need it

RFFE stands for "Radio Frequency Front End" and the "1" stands for the first version (0-62.5 MHz coverage). When I was designing the QS1R board, I had to decide whether to include bandpass filtering and RF amplification on the board. In fact the initial prototypes "RevA" included RF amplification on the QS1R board. Unlike another DDC based direct sampling receiver "Perseus", QS1R was designed to be more than a SW receiver. In addition to a SW receiver, QS1R was meant to facilitate experimentation in the RF spectrum up to at least 300 MHz. I finally settled on a 55 MHz low pass filter (which can be bypassed) and no active components in front of the ADC on QS1R. Any active devices, bandpass filters, or attenuation would be added by a separate board such as the RFFE1. The antenna that I use for my QS1R is a center fed, non-resonant dipole at 50 feet. The total wire length is about 240 feet with only about 100 feet of that running horizontally...
Post a Comment
Read more